Engineers Edge
FEA using Pro-E Question
Post Reply   Forum
Posted by: manulal

12/28/2004, 02:22:17

Author Profile
eMail author
Edit

Hi,

Is FEA & animation possible in Pro-E ? Is Pro-E 2001 package sufficient enough for these two?

Manu.

 








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: FEA using Pro-E
Re: FEA using Pro-E -- manulal Post Reply Top of thread Forum
Posted by: Cragyon
Bart
12/29/2004, 18:40:42

Author Profile
eMail author
Edit

Check out the pro-e website.  There should be a capabilities and add-on packages definitions and apcifications available.







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Re: FEA using Pro-E Sad
Re: Re: FEA using Pro-E -- Cragyon Post Reply Top of thread Forum
Posted by: Yin

04/17/2007, 03:45:38

Author Profile
eMail author
Edit

why you do not use Ansys




------------------------

part-time for ever




Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread
Re: FEA using Pro-E
Re: FEA using Pro-E -- manulal Post Reply Top of thread Forum
Posted by: kostakis

12/29/2004, 06:12:12

Author Profile
eMail author
Edit

Of course you can do FEA in Pro/e. You can draw a part and then you can do simulation.







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer