bending beams

bending beams
	Post Reply		Forum

Posted by: catbrandt ^®

06/22/2006, 09:50:40

Author Profile eMail author Edit

I am trying to build a shelf out of angle iron that will hold a total weight of 661.5lbs. The three supports are spaced at follows, 23.75" from left end, then 84.5" to next support, then 121.5" to next support, then 22.25" to other end. I have shown a drawing of how the supports look. It is a bad drawing but it is the only way I could figure out how to post it. Any help would be greatly appreciated.

Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post

View All

| |

Replies to this message

Re: bending beams

Re: bending beams -- catbrandt Post Reply Top of thread Forum

Posted by: Scooter ^®

06/22/2006, 12:26:23

Author Profile eMail author Edit

You show an end view. It's ok, could you show a Front View & add dimentions. Also, a "Birds eye" view would help.
With this I think some one can help you with this design.
Thanks,
Scooter

Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post Where am I? Original Top of thread

Re: bending beams
Re: bending beams -- catbrandt	Post Reply	Top of thread	Forum