Engineers Edge
2 or 3 part steel pipe clamp
Post Reply   Forum
Posted by: Interpol

12/05/2006, 06:07:33

Author Profile
eMail author

I'm new on here and could really do with some help.

I need to design a steel clamp to fit on a 425mm diameter pipe. I need to determine the clamping pressure and the bolt load required. The clamp needs to support a load of 5.5 Tonne.

I envisage a 2 or 3 part fabricated clamp with bolted connections.

Any help would be very much appreciated.

Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post

Powered by Engineers Edge

© Copyright 2000 - 2019, by Engineers Edge, LLC All rights reserved.  Disclaimer