|
||||||||||||
|
||||||||||||
| pipe thread help | |||
| Post Reply | Forum | ||
| Posted by: hjens56 ® 02/05/2007, 15:06:56 Author Profile eMail author Edit |
Need a little help on pipe thread size. I have to run air into a port on a japanese robot but I am confused by the size of the port on the spec sheet. It says that the port sizes are "D4, PT 1/8" and "D6, PT 1/4". I believe that the D4 and D6 are the pipe diameters in millimeters within the robot, but I don't know what the PT means. From trying an NPT fitting, I have found that the port isn't NPT. Could it be BSPT or perhaps something else that I am unfamiliar with? Is there a standard that is used on japanese products? Thanks for the help. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| Re: pipe thread help | |||
| Re: pipe thread help -- hjens56 | Post Reply | Top of thread | Forum |
| Posted by: devitg-02 ® 02/08/2007, 07:33:46 Author Profile eMail author Edit |
D4, and D6 , are NOMINAL way of naming 1/8" and 1/4" pipe , and as far as I know Japan use BSPT standard. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
