Engineers Edge

[Home] [Design Resources] [Engineering Jobs] [Tell A Friend] [Technology Store]

Re: Special Screw
Re: Special Screw -- Domenick Post Reply Top of thread Forum
Posted by: Jim Disharoon

11/19/2002, 16:51:38

Edit
Consider using a locking screw, formed on the threads at the area of engagement: either with an applied nylon 'patch'(esentially melted nylon), or a pellet (inserted into drilled hole) or a strip (inserted into milled longitudinal slot.All create a locking 'bulge' on one side of the male threads, thereby both insuring positive position and assured contact with the opposing mated threads. See Mil-F-18240 and/or IFI-124 (Industrial Fastener Institute).








Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2019, by Engineers Edge, LLC All rights reserved.  Disclaimer