Engineers Edge

[Home] [Design Resources] [Engineering Jobs] [Tell A Friend] [Technology Store]

Speed Reducer Help Welcome!
Post Reply   Forum
Posted by: Pedro Lobo

11/26/2002, 15:37:27

Edit
Im a mechanical eng student and Im doing a project of a speed reducer with the following data:-input power 5.5 kw at 1500 rpm-two horizontal output shafts aligned with 200 rpm and 300 rpms conter rotating-horizontal inputIve calculated all the ratios but im having problems with the number of teeth required for each set of gears.The ratios are the following:from input to the 300 rpm output1/1.8 cone gears1/1.63 cylindrical gears1/1.63 cylindrical gearsfrom input to 200 rpm output1/1.8 cone gears 1/4Any coments will be welcome.Best regards Pedro Lobo








Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message

-----Re: Speed Reducer Help Welcome! Randy Kimball 0 685 bytes 11/26/2002, 18:29:17
-----Re: Speed Reducer Help Welcome! Serdar Yorulmaz 0 1014 bytes 11/27/2002, 12:16:17
-----Re: Re: Speed Reducer Help Welcome! Pedro Lobo 0 100 bytes 11/27/2002, 22:56:18
-----Re: Re: Speed Reducer Help Welcome! Randy Kimball 0 153 bytes 11/28/2002, 12:04:35
-----Re: Re: Re: Speed Reducer Help Welcome! Pedro Lobo 0 364 bytes 11/29/2002, 09:36:57
-----Re: Speed Reducer Help Welcome! chuah 0 295 bytes 01/09/2003, 08:02:20
-----Re: Re: Speed Reducer Help Welcome! saiful bahrin 0 1023 bytes 03/20/2003, 06:49:28

Powered by Engineers Edge

© Copyright 2000 - 2019, by Engineers Edge, LLC All rights reserved.  Disclaimer