|
3d cross section in pro E | |||
Post Reply | Forum |
Posted by: efendy ® 11/12/2009, 04:44:24 Author Profile eMail author Edit |
Hi All, Does anyone knows how to make 3d cross section in Pro-E? I know how to make the cross section by offset command. But to make something like the picture I attached, especially in the red line is a pain for me. Please someone help me. Thanks.
Modified by efendy at Thu, Nov 12, 2009, 04:45:19 |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | |
Replies to this message |
Re: 3d cross section in pro E | |||
Re: 3d cross section in pro E -- efendy | Post Reply | Top of thread | Forum |
Posted by: wwdaugherty ® 11/25/2009, 09:06:59 Author Profile eMail author Edit |
To recreate that illustration EXACTLY, the only technique that comes to mind is an assembly cut. Awkward, yes, but it could produce the desired effect. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer