Results 1 to 2 of 2

Thread: Postion Tolerancing - Urgent Help !

  1. #1
    deepesh
    Guest

    Postion Tolerancing - Urgent Help !

    Hi All,


    I have little experience with using GD&T. I have a 8mm plate in which there are 12 bushings. The location of these bushings are critical.
    In-order to control this, i have made 1 bushing as Datum B, and given position tolerance of 0.3mm. All the other bushings are referenced to this. Datum A is the bottom surface of the part.
    IS this drawing OK? Please find the attached picture of the drawing.
    Attached Images Attached Images

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Yes, except you do not have a practical ~ datum or dimensional control of the pattern of features vertically. You do have a basic (TED) dimension but no datum reference from the plate (vertically) to the pattern of bushings. That basic dimension tolerance is best described as a gauge tolerance since this is how basic dimension locations or distances are created in the real world.

    How does the plate with the bushings locate and orient in the target assembly?

    My instincts tell me that you probably need a composite position tolerance to tie the pattern of features to the plate and the bushing location to each other.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •