Results 1 to 2 of 2

Thread: question about online beam calculator vs equation

  1. #1
    Associate Engineer
    Join Date
    Dec 2017
    Posts
    1

    question about online beam calculator vs equation

    Hi! I was working out how to determine the stress and deflection of a length of aluminum hollow square section tubing. Doing pretty good until I tried to match the results of one of these online calculators and my own calculations using the equation given. I get a result of half the stress. Usually I think the tool is broken until I learn what my own mistake was, so I'm hoping you'll help me spot it.

    Here's the deets:

    online calculator here: https://www.engineersedge.com/beam_b...flection_2.htm
    stress equation here: https://www.engineersedge.com/beam_b...m_bending1.htm

    I wanted to verify my own calc on 'stress at any point,' the figure given by the calculator was -6388.889, my result was -3194 (half!)

    attached is an image with my variables included: I=.9, E (irrelevant for this portion) = 10,000,000, distance to centroid=1

    thanks for having a look!

    Attached Images Attached Images

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    The equations that go with the calculator are here:

    https://www.engineersedge.com/beam_b..._bending2e.htm
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •