Results 1 to 2 of 2

Thread: Design considerations for a worm gear sets using helical gears

  1. #1

    Post Design considerations for a worm gear sets using helical gears

    Hello,
    I am trying to design a simple worm gear set using a worm and a helical gear, but I couldn't figure out what conditions must be met for the worm and the gear to mesh properly.

    The intent of the design is for a tuner device (like those found on guitars for example),it seems very common for guitar tuners to use this particular combination to reduce cost and because the extra inefficiency is not really noticed.

    From what I understand they must have the same pitch and the same pressure angle, and the axis of rotation must be at a particular distance and orthogonal to each other.

    Is it possible to use a standard ISO metric thread profile for the worm instead of the conventionally used ASME like threads ?

    Please excuse my ignorance, I never designed any worm gear train before.

    Thank you in advance

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    See:

    https://www.engineersedge.com/calcul...tors_15310.htm

    Which is per. industry standard ANSI/AGMA 6034-B92
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •