Results 1 to 2 of 2

Thread: Standards & Symbols on the drawing Plastic Moulded parts

  1. #1

    Join Date
    Jul 2022
    Posts
    1

    Standards & Symbols on the drawing Plastic Moulded parts

    Hello group.

    Looking for Standards Number that can explain the meaning of symbols used on drawings of Plastic Molded Parts.

    Recently I found website, and drawing of molded part (attached below).

    ISO 20457:2018 - Tolerances for plastic moulded parts - Information on the new standard

    Some symbols specified on the drawing used only on drawings of molded parts and we did not meet it in the past.

    Could anyone to advise Standards Numbers that can explain the meaning of these symbols?

    iso-10135.png

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,611
    ISO 20457
    ISO 10135

    From left to right:

    Part Ejector locations, size, and markings,
    Sink marks not greater than,
    Surface Enlargement allowed for manufacturing optimization

    - and the site you linked to (removed) provided training on the interpretation of the annotation.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •