Share |

Draft


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Donald on April 10, 2002 at 15:32:26:

We are an injection molder with a part drawn to Y14.5M-1982. In the standard list of notes it says "Draft angles to be within specified tolerance" In one of the part views it has "0.5 dagree max draft". The standing retangular feature has a true position call out, and standard box tolerances.
My questions are which draft callout takes presentance for this feature and can the draft exceed tolerance?

Thanks,
Don


Follow Ups



< "> Subject: Re: Draft

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer