Share |

Re: Re: Gearbox Design


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by XCXZ (216.250.212.135) on November 21, 2002 at 22:45:56:

In Reply to: Re: Gearbox Design posted by Randy Kimball on October 06, 2002 at 12:15:09:

: Mark?
: That is a 100 HP motor with a 9-1 gear ratio?

: Be sure to supply ample dia. shafts.!!
: I'd go with either the 15-5SS or 4140HT if it were me.
: ... geeeze ... be careful, a slight % error is
: going to result in a large difference in forces.

: Note: 15-5ss has a wonderful ability to take flex
: and twist and hang in there, grain is important to
: consider, but in a round bar the grain will be
: linier as you want it to be. .... geeeze ...

: I've never designed a torque shaft so big and
: with such forces, I hope someone else has and will
: support or correct my suggestion. Please do not
: design these shafts on my suggestion alone for
: this reason. ...





Follow Ups:



Post a Followup

< "> Subject: Re: Re: Re: Gearbox Design

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer