Replies to this message

Re: Platform raised w/ gear config
Re: Platform raised w/ gear config -- rsickinger	Post Reply	Top of thread	Forum

Posted by: randykimball ® 03/27/2005, 10:03:32 Author Profile Mail author Edit

Ray, I'm not sure we understand what your question is. Are you looking for a formula for lifting 250 lbs, if so we need to know the size and weight of the platform and the distance the load will be from the pivot. If you are asking for design help, please ask for an engineer to contact you of which is skilled in that area. Perhaps there is another question you need answered that would get you started. Thank you, -randy- The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: Platform raised w/ gear config
Re: Re: Platform raised w/ gear config -- randykimball	Post Reply	Top of thread	Forum

Posted by: rsickinger ® 04/05/2005, 07:24:34 Author Profile Mail author Edit

Randy. Thanks for the advice. Now I am not sure what we are doing. Things are up in the air right now. Once we get settled, I will repost with more detail. Thanks Ray

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: Platform raised w/ gear config
Re: Re: Platform raised w/ gear config -- rsickinger	Post Reply	Top of thread	Forum

Posted by: raghudon ® 04/20/2005, 13:24:11 Author Profile Mail author Edit

what you are basically looking for is a dock leveller design. The easiest way is hydraulically using one hydraulic cylinder to lift and hold the load Raghu Nandan Enterprises

Post Reply | Recommend | Alert

Where am I? Original Top of thread