Engineering Design Data: Menu - manufacturing

 
manufacturing engineering design
Prev Page | Next Page

Pages: 1 [2] 3

ISO Surface Roughness Symbols Terminology
The principal ISO standard that specifies syrface roughness is ISO 1302 and defines the surface roughness symbology and additional requirements for engineering drawings. The details in ISO surface finish standards relate to surfaces produced by abrading, casting, coating, cutting, etching, plastic deformation, sintering, wear, erosion, and some other methods.
Aluminum Extrusion Dimensions and Tolerances Specification
The industry's standard tolerances were developed by technical committees of The Aluminum Association and the American National Standards Institute..
Sand casting Vacuum Molding V-Process
Vacuum molding (V-process) is a variation of the sand casting process for most ferrous and non-ferrous metals, in which unbonded sand is held in the flask with a vacuum.
Turning lathe cutting tool forces
Tool forces vary with cutting speed, feed rate, depth of cut and rake angle. Force may be measured experimentally by using a 'cutting tool dynamometer' in which the tool is mounted on a flexible steel diaphragm and its deflections in three planes measured by three electrical transducers.
Gas Assist Injection Molding
Ever wondered if there were other techniques for injection molding that might benefit your product design? Gas assist molding can offer specific benefits for certain types of product designs.
Rotational Molding Review
Rotational molding, also referred to as rotomolding, rotocasting or spin casting, is a plastic molding process for manufacturing rigid hollow shell parts
Center Line Chip Loads & SFM RC Hardness
Center Line Chip Loads and SFM by RC Hardness . The following tables specify the Center Line Chip loads and SFM RC Hardness for various engineering materials and high speed end mill cutters.
Machinability Tool Factors
Machinability Tool Factors Charts and Tables. The term machinability refers to the ease with which a metal can be machined to an acceptable surface finish. Materials with good machinability require little power to cut, can be cut quickly, easily obtain a good finish, and do not wear the tooling much; such materials are said to be free machining.
Grit Sand Blasting Equipment Review
Grit or sand blasting equipment is utilized to clean and prepare surfaces by directing a medium to high pressure stream of abrasive particles against the component surface.
Shot Peening Equipment Review
Popular methods utilized in shot peening machinery for propelling shot media include air blast systems and centrifugal blast wheels. In the air blast systems, media is introduced by various methods into the path of high pressure air...
Prev Page | Next Page

Pages: 1 [2] 3

© Copyright 2000 - 2017, by Engineers Edge, LLC All rights reserved.
Disclaimer