Engineering Design Data: Menu - manufacturing

 
manufacturing engineering design
Next Page

Pages: [1] 2 3

ANSI Taps Fraction-Size Tolerances Per ASME B94.9
Engineering and manufacturing ANSI Taps Fraction-Size Tolerances Per ASME B94.9. All dimensions are given in inches.
How to use a Surface Roughness Comparator
How do I use a surface roughness comparator? Surface roughness comparators are used within industry to measure or verify the as-manufactured surface finish (roughness) of a part or assembly. Comparators are selected and used based on the manufacturing process used to create a particular surface finish. Industry standard manufacturing specific roughness comparators are available for the following processes:
Pilot Holes and Field Matching Drilling Aluminum and Steel
To make a fastener hole of the correct size, first drill a hole slightly undersize. This is known as predrilling, and the hole is called a pilot hole. Ream the pilot hole with a twist drill of the correct size to get the required dimension. General pilot and reaming drill sizes for aluminum rivets are shown in the table below.
Press Brake Forming Force Equation and Calculator
Estimate the force (tonnage) for a press brake to bend or form sheet metal Equation and calculator.
Morse Taper Shanks Dimensions Table
Morse Standard Taper Shanks Dimensions and Tolerance Table.
Jarno Taper Size Chart Table
Jarno Taper Size Chart. Jarno tapers have a of taper of about 1:20 on diameter, or .600 inches on diameter per foot, or .050 on diameter per inch.
Jig Boring Jig Borer
Jig bore machine are used for precision hole-location work. To accomplish this the coordinate measuring systems on these machines are designed and manufactured to provide longitudinal and transverse movements that are accurate to 0.0001 in. or better.
Screw Extractor Size and Drill Table Chart
Table of screw bolt extractor sizes and pre-drill size required to use screw extractor easy-out.
Brinell Hardness Test Equation
The Brinell scale characterizes the indentation hardness of materials through the scale of penetration of an indenter, loaded on a material test-piece. It is one of several definitions of hardness in materials science.
Preferred Mechanical Tolerances Metric ISO 286
The following defines the preferred tolerance basis for hole and shaft per. ISO 286.
Next Page

Pages: [1] 2 3

© Copyright 2000 - 2019, by Engineers Edge, LLC All rights reserved.
Disclaimer