Engineering Design Data: Menu - pressure-vessel

 
Pressure Vessel Design and Engineering
Next Page

Pages: [1] 2

Gas Discharge Rate Atmosphere From a Pressure Vessel
Gas Discharge Rate Atmosphere From a Pressure Vessel - When a gas is stored under pressure in a closed vessel is discharged to the atmosphere through an orifice, the gas velocity through that orifice may be choked or non-choked.
Pressure Vessel Roundness Tolerance
Maximum Allowed Out of Circular Form (Roundness) for Pressure Vessel Under External Pressure - Designation e.
ASME BPVC Rules Summary and Overview
ASME Section VIII - Rules for Construction of Pressure Vessels. The section of the ASME BPVC consists of 3 divisions. Division 1: This division covers the mandatory requirements, specific prohibitions and non-mandatory guidance for materials, design, fabrication, inspection and testing, markings and reports, overpressure protection and certification of pressure vessels having an internal or external pressure which exceeds 15 psi (100 kPa).
Hydrostatic Pressure Tests ASME Pressure Vessels
Pressure vessels designed for internal pressure shall be subjected to a hydrostatic test pressure which at every point in the vessel is at least equal to 1.3 times the MAWP multiplied by the lowest ratio for the materials
Seamless Full-Hemispherical Head ASME Pressure Vessel Equations and Calculator:
ASME Pressure Vessel Section I: Seamless or Full-Hemispherical Head Equations and Calculator
Dished Head Equation and Calculator Pressure Vessel Equations and Calculator
ASME Pressure Vessel Section I: Dished Heads Formulae: Equations and Calculator:
Dished Head Formula hemispherical, elliptical ASME Pressure Vessel Section I Equations and
The ASME Section VIII – Division 1 determines the rules for dished heads. The most common configurations are spherical, hemispherical, elliptical (or ellipsoidal) and torispherical shapes.
Reinforcement Wall Thickness Plate ASME Pressure Vessel Section VIII Equations and Calculator:
Standard design method uses an increased wall thickness plate at the equator line of the vessel to support the additional stresses caused by the attachment of the legs.
Pressure Piping Minimum Wall Equations and Calculator:
ASME I and ASME-ANSI B31 – Pressure Piping Minimum Wall Thickness: Equations and Calculator
Weld Joint Reduction Factor for Pressure Vessel and Piping
Pressure Vessel and Piping Weld Joint Reduction Factor - Weld Joint Corrosion Reduction Factor
Next Page

Pages: [1] 2

© Copyright 2000 - 2017, by Engineers Edge, LLC All rights reserved.
Disclaimer